I knew the minute I saw the Wildlife Wonder stamp set that I had to have it. I love making simple masculine cards especially when the Designer Series Paper (DSP) does the “heavy lifting”
I’m submitting this card to The Paper Players challenge for a wildlife CAS card.
This set doesn’t have dies but it’s easy to fussy cut. I have a few tips to make it look like it’s perfect even if it isn’t. I stamped my image on Basic White card stock & cut as close as I could without cutting into the inked area.
FIRST TIP: Color with the brush end of marker any white areas that shows around the edges from fussy cutting. Use the brush marker around the entire edge. Use the same color marker as your stamped image; here, I used Soft Suede.
Below is a close up where I colored along the bear’s back but not the legs. [some of the bear’s backside will eventually get cut off but I colored it all because I wasn’t sure exactly what would get cut off].
SECOND TIP: Stamped the image directly on the background paper before adding the fussy cut image. Here, the bear was stamped on the New Horizons DSP. Even though you won’t see the image when you add your fussy cut image on top of the background image there may be details that were cut off with fussy cutting. The bear is popped up on dimensionals.
Below are two close-ups. Look at the front paw & the chin of the bear. The details of the claw and chin hair were cut away on the fussy cut but with the image stamped on the background, these details show. It gives the bear some depth & definition.
I stamped the sentiment on a piece of the same DSP & cut it out. One last look at the card. I hope you like it!
- Supplies: All Stampin’ Up
- Stamps: Wildlife Wonder
- Paper: Soft Suede, Evening Evergreen, Basic White
- DSP: New Horizons
- Ink: Soft Suede, & Soft Suede marker
- Technique: Fussy cutting